| |
| Mas-Con Company / E.R. Long Associates Manufacturers |
| |
Below are the manufacturers that our company trusts to complete your project. From moisture barriers to caulks and sealants - we provide our clients only the best.
For manufacturers for our Masonry and Concrete accessories, please visit those pages. |
| |
|
|
 PROSOCO -
Water Repellents for stucco, masonry, and veneer stone.
Repellent page- Siloxane PD- Best choice most masonry facades
|
|
Form Release Agents
 Cresset Chemical Company manufacturers 727 and 880VOC Form Release agents for the precast and poured in place concrete market . The ability of 727 form release to not only give a smooth finish, but to also clean forms the more it is used make it an ideal choice for those poured wall contractors who want to save time and labor, and take care of the investment made in their forms. Both 880 and 727 are architectural release agents that do not transfer onto the concrete after the pour is made. More information is available at Cresset.
|
|
|
|
| |
|
|
Eggshell |
Antique White |
Antique Champagne |
| |
|
|
Taupe |
Ivory |
Champagne |
| |
|
|
Fieldstone Gray |
Platinum |
Light Gray |
| |
|
|
These chips are meant to reflect the finished color as nearly as possible. Application and texture may cause some slight variations. See product literature and your stucco contractor for further information. Also available in white, custom colors available.
Consult Mas-Con / E.R. Long Associates for more details |
|
|
Masonry Control joints for block Bo Metals
Preformed masonry control joints-  available in standard size for all sizes of block, custom sizes for 8” and 12” block.
Specifications and details of products above can be obtained at Bio Metals web site
|
|
 Scapewell -The Scapewell system by Bilco provides an attractive daylight basement area wall that meets the IRC 2003 and 2006 Egress Code.
|
|
 Foundation drainage system used to form up footers and stay in place. Eliminate moving forming lumber from one hole to the next.
|
|
 the patent pending E-Z Bead™ plaster stop.
E-Z Bead™ is designed with a built-in strip for straight and uniform spacing around window and door frames or any other point where stucco meets a dissimilar material (e.g., soffits, fascia board, etc.).
|
|
 POLYMETRIC SYSTEMS, INC.
We solve your adhesive and sealant problems quickly and cost effectively.
 Mason Seal Adhesive and Joint Sealant- This flexible material is compatible with all types of masonry. Used as an adhesive to set retaining wall caps and pavers down onto concrete. Mason Seal sets in about 30 minutes and adheres aggressively to masonry. Mason Seals movement capability makes it ideal as an adhesive for masonry in freeze thaw climates where more brittle adhesives will lose their bond. This same material is also used as a joint sealant for masonry and concrete. The same movement capabilities meets + or – 25% movement requirements for concrete and masonry joints.
|
|
SIMPSON EPOXY
 Epoxy Tie adhesives- Simpson Epoxies are used as a high strength, non shrink anchoring and grouting material. Primary use is to set rods, dowels and anchors into concrete and masonry. Simpson ET22 is approved for Pennsylvania Dept of Transportation work. This material is packaged in side by side cartridges for easy application, saving time and Labor. Get more info at Simpson.
|
|
| |
|
